An Open Forum for Enforcer RC Boat Owners and Fans
Adam's Discussions
Engine Kill Guard
3 Replies
Tony,I hooked up the engine kill guard to my new enforcer boat, between the battery, receiver, and switch and the engine wires to the ground bolt on the coil and the other into the coil. I tested the…Continue
Started this discussion. Last reply by Gordon T Haley Jul 19, 2012.
Gifts Received
Adam has not received any gifts yet
Adam's Page
Profile Information
Adam's Blog
Cable not inserting fully
Hey Tony and fellow boaters. I just received my new Enforcer team pro 46" today and it looks awesome. Everything is ready to go except I can't get the shaft fully in as the cartridge assembly with the prop doesn't slide fully in to where the grove and screw should line up. It will line up fine without the shaft in place but not with the shaft so for some reason the shaft will not go up far enough, even with a large amount of force?? Also which end of the shaft goes into the clutch area? I…
ContinuePosted on April 21, 2012 at 2:01am — 3 Comments
© 2023 Created by Daniel Hofman.
Powered by
Comment Wall (1 comment)
Adam,
The overall length with the ferrule end to end is- 15, 1/8" + - .0125
Also make sure the slot on the SPD cartridge is facing up.
You need to be a member of Enforcer R.C. Boat Talk to add comments!
Join Enforcer R.C. Boat Talk