Enforcer R.C. Boat Talk

An Open Forum for Enforcer RC Boat Owners and Fans

Ok so after all the initial excitment was over it was time to start thinking about the build. The first job was to assemble the boat stand to allow me to set the boat up on the table.

This is the contents of the box including the instructions. Things to note is that the instructions refer to wood, guess there may be a different versions or and older one, but this is plastic and will no doubt do the job admirably. Also don't put the Enforcer stickers on upside down (and no, I didn't!). It's a tight fit so I didn't bother to glue it. Would like to see some better rope included as this nylon stuff is awful, I'll replace it when I get a chance.

Once assembled it should look a little like this, easy...

The Magnum 57 sitting pretty

Views: 139


You need to be a member of Enforcer R.C. Boat Talk to add comments!

Join Enforcer R.C. Boat Talk

© 2023   Created by Daniel Hofman.   Powered by

Badges  |  Report an Issue  |  Terms of Service