Enforcer R.C. Boat Talk

An Open Forum for Enforcer RC Boat Owners and Fans

May 2014 Blog Posts (2)

Search Blog Posts

Bonzi Clutch

  My box of parts showed up today from Bonzi. Clutch s a very nice looking piece! After test fitting to the engine noticed that the shoes are hanging out of the bell by about .125 so will have to shorten the spacers to get full shoe contact with the bell. No problem with the lathe! I chose WHH universal mounts so would have a fair amount of alignment adjustment. I will have to shorten the screws that hold the mount to the clutch since the half inch long ones run into the clutch bell. I think…

Continue

Added by Theodore Jon Berg on May 24, 2014 at 9:40pm — No Comments

SPD III drive

A friend told me of a good tip regarding the SPDIII drive. When you install a new stuffing tube let it hang out of the transom a bit. Then put a couple o-rings on the stuffing tube between the bracket and body of the drive. The reason for doing this is to lesson the grease that flows out all over the transom and force it to the cartage to lubricate the bearings.

Added by Gordon T Haley on May 17, 2014 at 5:16am — No Comments

Featured Blog Posts

View All

Latest Blog Posts

Most Popular Blog Posts

Monthly Archives

2023

2022

2021

2019

2016

2015

2014

2013

2012

2011

2010

© 2023   Created by Daniel Hofman.   Powered by

Badges  |  Report an Issue  |  Terms of Service